SOCKIO(4I) 4I SOCKIO(4I)

NAME

sockio - ioctls that operate directly on sockets

SYNOPSIS

#include <sys/sockio.h>

DESCRIPTION

The ioctls listed in this manual page apply directly to sockets,
independent of any underlying protocol. The setsockopt(3SOCKET) call (see
getsockopt(3SOCKET)) is the primary method for operating on sockets, rather
than on the underlying protocol or network interface. ioctls for a
specific network interface or protocol are documented in the manual page
for that interface or protocol.

SIOCSPGRP The argument is a pointer to an int. Set the process-group ID
that will subsequently receive SIGIO or SIGURG signals for the
socket referred to by the descriptor passed to ioctl to the
value of that int. The argument must be either positive (in
which case it must be a process ID) or negative (in which case
it must be a process group).

SIOCGPGRP The argument is a pointer to an int. Get the value of that
int to the process-group ID that is receiving SIGIO or SIGURG
signals for the socket referred to by the descriptor passed to
ioctl.

SIOCCATMARK The argument is a pointer to an int. Set the value of that
int to 1 if the read pointer for the socket referred to by the
descriptor passed to ioctl(2) points to a mark in the data
stream for an out-of-band message. Set the value of that int
to 0 if the read pointer for the socket referred to by the
descriptor passed to ioctl does not point to a mark in the
data stream for an out-of-band message.

SEE ALSO

ioctl(2), getsockopt(3SOCKET)

OmniOS October 29, 2017 OmniOS