CT(1C) Communication Commands CT(1C)


NAME


ct - spawn login to a remote terminal

SYNOPSIS


ct [options] telno...


DESCRIPTION


The ct utility dials the telephone number of a modem that is attached to
a terminal and spawns a login process to that terminal. The telno is a
telephone number, with equal signs for secondary dial tones and minus
signs for delays at appropriate places. (The set of legal characters for
telno is 0 through 9, -, =, *, and #. The maximum length telno is 31
characters). If more than one telephone number is specified, ct will try
each in succession until one answers; this is useful for specifying
alternate dialing paths.


ct will try each line listed in the file /etc/uucp/Devices until it finds
an available line with appropriate attributes, or runs out of entries.


After the user on the destination terminal logs out, there are two things
that could occur depending on what type of port monitor is monitoring the
port. In the case of no port monitor, ct prompts: Reconnect? If the
response begins with the letter n, the line will be dropped; otherwise,
ttymon will be started again and the login: prompt will be printed. In
the second case, where a port monitor is monitoring the port, the port
monitor reissues the login: prompt.


The user should log out properly before disconnecting.

OPTIONS


The following options are supported:

-h
Normally, ct will hang up the current line so that it can be
used to answer the incoming call. The -h option will prevent
this action. The -h option will also wait for the termination
of the specified ct process before returning control to the
user's terminal.


-sspeed
The data rate may be set with the -s option. speed is
expressed in baud rates. The default baud rate is 1200.


-v
If the -v (verbose) option is used, ct will send a running
narrative to the standard error output stream.


-wn
If there are no free lines ct will ask if it should wait, and
for how many minutes, before it gives up. ct will continue to
try to open the dialers at one-minute intervals until the
specified limit is exceeded. This dialogue may be overridden
by specifying the -wn option. n is the maximum number of
minutes that ct is to wait for a line.


-xn
This option is used for debugging; it produces a detailed
output of the program execution on stderr. n is a single
number between 0 and 9. As n increases to 9, more detailed
debugging information is given.


FILES


/etc/uucp/Devices


/var/adm/ctlog


SEE ALSO


cu(1C), login(1), uucp(1C), ttymon(1M), attributes(5)

NOTES


The ct program will not work with a DATAKIT Multiplex interface.


For a shared port, one used for both dial-in and dial-out, the ttymon
program running on the line must have the -r and -b options specified
(see ttymon(1M)).


September 14, 1992 CT(1C)