UNIX2DOS(1) User Commands UNIX2DOS(1)


NAME


unix2dos - convert text file from ISO format to DOS format

SYNOPSIS


unix2dos [-ascii] [-iso] [-7]
[-437 | -850 | -860 | -863 | -865] originalfile convertedfile


DESCRIPTION


The unix2dos utility converts ISO standard characters to the
corresponding characters in the DOS extended character set.


This command may be invoked from either DOS or SunOS. However, the
filenames must conform to the conventions of the environment in which the
command is invoked.


If the original file and the converted file are the same, unix2dos will
rewrite the original file after converting it.

OPTIONS


The following options are supported:

-ascii
Adds carriage returns and converts end of file characters in
SunOS format text files to conform to DOS requirements.


-iso
This is the default. Converts ISO standard characters to the
corresponding character in the DOS extended character set.


-7
Converts 8 bit SunOS characters to 7 bit DOS characters.


On non-i386 systems, unix2dos will attempt to obtain the keyboard type to
determine which code page to use. Otherwise, the default is US. The user
may override the code page with one of the following options:

-437
Use US code page


-850
Use multilingual code page


-860
Use Portuguese code page


-863
Use French Canadian code page


-865
Use Danish code page


OPERANDS


The following operands are required:

originalfile
The original file in ISO format that is being converted
to DOS format.


convertedfile
The new file in DOS format that has been converted from
the original ISO file format.


SEE ALSO


dos2unix(1), ls(1), attributes(5)

DIAGNOSTICS


File filename not found, or no read permission

The input file you specified does not exist, or you do not have read
permission. Check with the SunOS command, ls -l (see ls(1)).


Bad output filename filename, or no write permission

The output file you specified is either invalid, or you do not have
write permission for that file or the directory that contains it.
Check also that the drive or diskette is not write-protected.


Error while writing to temporary file

An error occurred while converting your file, possibly because there
is not enough space on the current drive. Check the amount of space
on the current drive using the DIR command. Also be certain that the
default diskette or drive is write-enabled (not write-protected).
Notice that when this error occurs, the original file remains intact.


Translated tmpfile name = filename.
Could not rename tmpfile to filename.

The program could not perform the final step in converting your file.
Your converted file is stored under the name indicated on the second
line of this message.


September 14, 2000 UNIX2DOS(1)